【Floor】Identify the quality of SPC lock floor at a glance!

01

Check whether the overall pattern of the lock floor is consistent, and whether the pattern on the floor surface is clear and delicate. It is also necessary to pay special attention to whether the floor locks are straight and smooth, which directly affects the effect of the later paving of the floor.

02

PVC plastic floor uses polyvinyl chloride material and selected non-radioactive marble powder. Polyethylene plastic is an environmentally friendly and non-toxic renewable resource. All the ingredients added in the production process are completely non-toxic and non-radioactive, and do not contain any heavy metals. Therefore, there is no pungent smell if you smell it close to the surface. The smaller the smell, the better the quality. It should be noted that after the lock floor leaves the factory, the longer it is placed, the less the smell will be.

03

The drip test is divided into two aspects: the first is to test whether the floor locks are connected to see if there is water leakage; the second is to test the anti-slip performance of the floor.

First, take out two lock floors at will, connect them naturally with locks, and lay them flat on the ground. Then drip water droplets on the joints. After standing for 3-5 hours, wipe the water clean with a dry cloth, separate the two floors, and check whether there are water marks in the card slot.

SPC lock floor uses polyvinyl chloride material, which does not absorb water, but becomes astringent when exposed to water, so it is non-slip and moisture-proof.

When testing the slip resistance, it can also be done by dripping water. Put a few drops of water on the floor first and rub it with your hands. There is no slippery feeling, the more astringent the better.

04

Through the light irradiation, it can be basically judged whether the lock floor is produced with new materials or recycled materials. This test is also relatively simple, you can turn on the flashlight of the mobile phone, press it against the floor of the lock, and then observe from the other side to see if you can see the bright spot of the light source. Under normal circumstances, all new materials can be seen.

05

The surface of the SPC lock floor has a special, high-tech processed transparent wear-resistant layer, which determines the wear resistance of the plastic floor. You can scrape the surface of the floor with your nails. If the quality of the lock floor is good, there should be no traces on the surface.